industrial 3D model Tape cutters including DFM
$10
This is industrial 3D model Tape cutters including DFM
Brief introduction of the operation procedure of the 3D model strip cutting fixture:
1. Manually load the bending elements into the lower die locator pin for positioning
2. Manually push the bottom die into the bending fixture, with hard limit and sensor touch.
3. The bending drive cylinder presses down to bend the product at a certain angle.
4. Remove the bottom mold and craft product after finished.
Industry use: Equipment
3D model Design software: SolidWorks
3D model Version/edit:2017 [editable, with parameters]
3D model file format:Sldprt Sldasm x_t
This is industrial 3D model Tape cutters including DFM
Brief introduction of the operation procedure of the 3D model strip cutting fixture:
1. Manually load the bending elements into the lower die locator pin for positioning
2. Manually push the bottom die into the bending fixture, with hard limit and sensor touch.
3. The bending drive cylinder presses down to bend the product at a certain angle.
4. Remove the bottom mold and craft product after finished.
Industry use: Equipment
3D model Design software: SolidWorks
3D model Version/edit:2017 [editable, with parameters]
3D model file format:Sldprt Sldasm x_t
Related products
